1. ... NO STANDARD PAGE HEADING
2. ... LINE-SIZE col
3. ... LINE-COUNT lin(n)
4. ... MESSAGE-ID xx
5. ... DEFINING DATABASE ldb
Introduces the report. You can choose any name you like
up to 8 characters long.
Only standard SAP reports should begin with 'R'.
... NO STANDARD PAGE HEADING
Suppresses output of the standard page header (see
... LINE-SIZE col
Creates a report with col columns per line. The
maximum line length permitted is 255 characters.
If the LINE-SIZE specification is missing, the line length
corresponds to the current screen width. The system field
SY-LINSZ contains the current line size for generating reports
(see NEW-PAGE ... LINE-SIZE ).
The specified LINE-SIZE must not appear in
If the you want the report list (i.e. the output) to be printable,
do not define a LINE-SIZE with a value greater than 132 because
most printers cannot handle wider lists.
REPORT ZREPNAME LINE-SIZE 132.
... LINE-COUNT lin(n)
Creates a report with lin lines per page, of
which n lines are reserved for the
END-OF-PAGE processing. If you
omit the " (n) ", the default value 0 applies. The system field
SY-LINCT contains the current number of lines per page for
If the LINE-COUNT specification is missing, the number of lines
per page is calculated dynamically from the number of lines actually
output on this page. Here, a page break no longer occurs automatically,
but must be specified explicitly with
NEW-PAGE , and the system field
SY-LINCT is set to 0. (NEW-PAGE ... LINE-COUNT
The LINE-COUNT must not be enclosed in quotation
Further information about using
The page has 65 lines.
REPORT ZREPNAME LINE-COUNT 65.
The page has 65 lines, of which the last 8 are only defined by
REPORT ZREPNAME LINE-COUNT 65(8).
... MESSAGE-ID xx
Takes the messages output by
MESSAGE under the specified
2-character ID xx from table T100 .
This ID must not be enclosed in quotation marks.
REPORT RSTEST00 MESSAGE-ID SY.
... DEFINING DATABASE ...
All the database programs must specify in the
REPORT statement the three-character name of the logical
database to which they belong.
This addition is generated automatically (in the REPORT
statement) when you create a logical database by selecting
Utilities -> Development/test -> Logical databases .
REPORT SAPDBKDF DEFINING DATABASE KDF.
© SAP AG 1996